> > There is a small bug in the mfe.c initialization for the EQ_POLLED mode. There 
> > is a routine where the number of polls fitting in eq_info->period is counted:
> > 
> > 
> >          count = 1;
> >          do {
> >             if (display_period)
> >                printf(".");
> > 
> >             start_time = ss_millitime();
> > 
> >             poll_event(equipment[idx].info.source, (INT)count, TRUE);
> > 
> >             delta_time = ss_millitime() - start_time;
> > 
> >             ...
> > 
> >             if (delta_time > 0)
> >                count = count * eq_info->period / delta_time;
> >             else
> >                count *= 100;
> >             
> >             // avoid overflows
> >             if (count > 2147483647.0) {
> >                count = 2147483647.0;
> >                break;
> >             }
> >             
> >          } while (delta_time > eq_info->period * 1.2 || delta_time < eq_info-
> > >period * 0.8);
> > 
> > As "start_time = ss_millitime();" resets "delta_time" each time, only the 
> > "avoid overflows" addition saves the day. 
> > 
> > start_time = ss_millitime(); show be out of the loop.
> 
> Nope.
> 
> What I want is to determine how often I have to call poll_event to stay there for a certain time (usually 100ms). So I iterate "count" until I roughly get to my 100ms. Each call to 
> poll_event with a different count is a new measurement, therefore I initialize start_time before each measurement. If i do it outside the loop, and kind of incrementally increase 
> it, then the whole code inside the loop is added to the measurement which makes it (slightly) wrong.
> 
> The whole loop optimization has some background. Polling can be sow (think of talking to a device via Ethernet which can easily take milli seconds). So how often do we poll 
> before we do other things in the main look (like looking if a run has been started). If I only poll once, then the average front-end response time would be poor, because I mostly 
> look if a run has been started in the main loop. This is not effective. If I poll too often inside the poll_event loop, then the front-end does not react on run stops any more. So 
> there is some optimum, and this is set by the polling time of usually 100ms. This ensures that the front-end does optimal polling - without ANYTHING in between - for about 
> 100ms. But how can I know how often I should poll for 100 ms? As said above, polling can be very fast (reading a memory cell) or very slow (network). The the best method I 
> found is to do a calibration at the startup, and this is what the code above does. Maybe there are better ways today, but that code worked nicely in the last 25 years.
> 
> Stefan

Thanks, I misunderstood the loop then. If poll_event(equipment[idx].info.source, (INT)count, TRUE); doesn`t do anything with "count", the loop becomes infinite except for the overflow 
check.