Dear all,
       I'm writing a very simple device driver starting from the nulldev.cxx 
example. 

I define an equipment as reported at the end of this message then, if all 
variables are Input variables, I define them with:

  mdevice device("myEquimpent", "Input", DF_INPUT | DF_MULTITHREAD, mydevice);
  device.define_var("Var1", 0.1);
  device.define_var("Var2", 0.1);
  ...

If all variables are output variables, I define them with:

  mdevice device("myEquipment", "Output", DF_OUTPUT | DF_MULTITHREAD, mydevice);
  device.define_var("Var1", 0.1);
  device.define_var("Var2", 0.1);

But I don't know what to do if I have mixed input and output variables in the same 
device. I think I can do:

  mdevice device_in("myEquipment", "Input", DF_INPUT | DF_MULTITHREAD, mydevice);
  device.define_var("Var1", 0.1);

  mdevice device_out("myEquipment", "Output", DF_OUTPUT | DF_MULTITHREAD, 
mydevice);
  device.define_var("Var2", 0.1);

but in this case, inside mydevice.cxx, I don't know how to distinguish Var1 and 
Var2, because they are both identified as channel 0.

Do you have any suggestion?

Thank you,
      Francesco




-------------------------------------------------------------------



   {"SourceMotor",                       /* equipment name */
    {7, 0,                       /* event ID, trigger mask */
     "SYSTEM",                  /* event buffer */
     EQ_SLOW,                   /* equipment type */
     0,                         /* event source */
     "MIDAS",                   /* format */
     TRUE,                      /* enabled */
     RO_ALWAYS,        /* read when running and on transitions */
     60000,                     /* read every 60 sec */
     0,                         /* stop run after this event limit */
     0,                         /* number of sub events */
     1,                         /* log history every event */
     "", "", ""} ,
    cd_multi_read,                 /* readout routine */
    cd_multi,                      /* class driver main routine */
   },