| Date |
User |
Note |
| 2018-03-09 00:00:00 |
{"user_name":"root"} |
Module boots with sof file.
bad qspi flash, prg gives flash ID error |
| 2018-03-19 00:00:00 |
{"user_name":"kong"} |
Regulators and references good. 4V @ 1.505A, 2.5V @ 0.076A |
| 2018-03-19 00:00:00 |
{"user_name":"kong"} |
Checked CONFIG IC pins (N25Q256A13EF840E). Power and pullup resistors ok. |
| 2018-05-02 00:00:00 |
{"user_name":"kong"} |
Replaced N25Q256A13EF840E IC |
| 2018-05-11 00:00:00 |
{"user_name":"lmartin"} |
Quartus error
Error (209025): Can't recognize silicon ID for device 1. A device's silicon ID is different from its JTAG ID. [...] |
| 2018-06-01 00:00:00 |
{"user_name":"lmartin"} |
EPCQ chip not recognized, chip replaced, problem remains.
Module unrepairable for now. KO |
| 2020-10-04 00:00:00 |
{"user_name":"olchansk"} |
vcxo does not oscillate from power up, cannot run firmware. K.O.
|
| 2020-10-04 00:00:00 |
{"user_name":"olchansk"} |
quartus flash loader does not see the epcq flash memory. K.O. |
| 2020-10-06 00:00:00 |
{"user_name":"olchansk"} |
epcq nCS, DCLK, DQ0 are all 0.35V (should be 0V or 3.3V and show activity). K.O. |