> It would be good to pin point there the data is lost. This is the sequence:
> 
> frontend user code -> mfe.c code -> SYSTEM buffer -> mlogger -> disk
> 
> To see if correct data arrives to the SYSTEM buffer, run:
> mdump -z SYSTEM
> 
> To see if mlogger is receiving events from the SYSTEM buffer, run:
> mlogger -v ### mlogger should report all events, history and data
> 
> To see if mlogger writes events to disk, examine the disk file (in this case, you already did, data is not there).
> 
> I would guess that your data does not make it out from the frontend (mdump shows "nothing"),
> if data were to arrive into the SYSTEM buffer, it would make it to disk, unless
> mlogger is misconfigured (but you already checked that).
> 
> If you have trouble with the frontend framework code, you can try to switch from the mfe.c frontend
> to the newer c++ tmfe frontend (see progs/fetest_tmfe.cxx and progs/fetest_tmfe_thread.cxx).
> 
> K.O.

Good evening

I tried to reproduce the behavior in a very simple FE but it did not work out. The next thing for me would be to take the FE that is producing this behavior, replace all the device communication and data with dummies. If the problem is still there I would start to simplify as much as possible. 

Following the inputs of KO, I pin-pointed the data loss. The system buffer still gets the data but the mlogger does not write the data event. Then of course the data is also not anymore present in the data file. Therefore, I checked the logger settings again, Event ID and Trigger Mask still -1. Nothing else, at least from my point of view, that is misconfigured. Nevertheless, if it helps I can send my ODB settings. 

When doing the tests just before I found something else that probably can give a hint to the problem. The data is only lost if the time between two runs is long (a few seconds). As an example: If I run a sequence with a loop and after the FE stops the run the loop ends and the next run is started automatically, then only the first run has no data, which is the one after a longer time of no data taking. When I add a "WAIT Seconds 5" after the run before starting the next, not data is written to the disk for any run. I also found this once when adding a sleep(1) at the end of the FE readout function but back then did not think about it any further. 

Best, Ivo