BNMR: Custom Settings page

• BNMR overview
• Getting started
• Troubleshooting
• All BNMR pages
• Midas

Links

• BNMR
• Custom Status page
• Custom Parameters page
• Experimental Modes
• Getting Started

Introduction

After selecting the Experimental (PPG) Mode by pressing a button on the Custom Status page, the experimenter will need to review the parameters relevant to the selected Experimental (PPG) Mode.

Each of the Experimental (PPG) Modes is associated with a list of Mode Parameters. This parameter list is displayed on the Custom Parameters Page, which can be accessed from the Custom Status Page by any of the following:

• clicking the RunParams button at the top of the page
• clicking the same button used to select the PPG Mode
• clicking the link PPG/PSM Parameters

If the selected mode includes RF, the #PSM Parameters will also be displayed on the Custom Parameters Page. When the run is stopped, the user may change these parameters as desired by clicking on a button or link. When the run is in progress, the parameter values are shown, but cannot be changed.

Examples of the Custom Parameter Page

PPG Mode 2e (run stopped)

Figure 1 shows the Custom Parameter Page for Experimental (PPG) Mode 2e. The run is stopped, and parameters may be entered by clicking on the appropriate link. PPG Mode 2e include RF, so the #PSM Parameters as well as the #Mode Parameters are shown.

File:Bnqr 2e param page.png

Figure 1:Parameter page for Mode 2e with run stopped

PPG Mode 2e (run in progress)

Figure 2 shows the same page as Figure 1 except the run is now in progress. The parameter values are shown, but may not be changed. The run state window has changed from "Stopped" to "Running" and the Tune lines are not shown.

File:Bnqr 2e param page running.png

Figure 2:Parameter page for Mode 2e with run in progress

PPG Mode 2e (graphical mode)

The parameters for PPG Mode 2e can also be entered graphically as in Figure 3

File:Bnqr 2e param interact.png

Figure 3:Graphic parameter page for Mode 2e with run stopped